Use Fixture in Stand‑alone Mode

After you connect power to the fixture, press the Function button (Function button), use the Intensity encoder to navigate to one of the following stand-alone modes, and then press the Intensity encoder to select it:

  • Studio: Use one of three studio (white light) presets, or customize the presets.
  • Color: Use one of 12 color presets, or customize the presets.
  • Gel: Choose from a list of common gel colors.
  • Effects: Use a sequence, or customize a sequence.
  • Preset: Use one of 12 presets (color preset + fade time), or customize the presets.

The colors of options on the display correspond to the colors of the encoders below the display and the Intensity encoder to the right of the display. Turn an encoder to modify the corresponding value on the display, or press an encoder to activate the corresponding option at the bottom of the display. Press the Intensity encoder to toggle between the current intensity and 0%.

If the fixture is connected to other LED fixtures that are in the same stand-alone mode, the connected fixtures will play the same preset or effect.

Note: If the colors on the display or on the encoders are difficult to discern, you can navigate based on position rather than color:

  • Intensity = Intensity encoder
  • From top to bottom (in main section of display):
    • Top value = Left encoder
    • Middle value = Center encoder
    • Bottom value = Right encoder
  • From left to right (at bottom of display):
    • Left value = Left encoder
    • Center value = Center encoder
    • Right value = Right encoder