-
If your RFU doesn't turn on, check the following: Check to see of RFU works in another location Plug the RFU directly into the back of the console (as opposed to a remote node). Make sure both (console and RFU) units are turned on and plugged in. Check the 1.6A fuse on the back of the console labeled...
-
These color codes apply to Belden 9729 and MOST equivalents. These color codes do not apply to Proplex. RFU: Pin 1: Red (of the red/black pair) Pin 2: Black (of the red/black pair) Pin 3: White (of the white/black pair) Pin 4: Black (of the white/black pair) Pin 5: Power - Pin 6: Power + See also: RFU...
-
ETC uses the Neutrik zero-degree pin offset, 6-pin connector for all 6-pin XLR remote focus unit connections.
-
The attached document provides guidelines for the different wire types, and their equivalents, that ETC recommends for low voltage data transmission in permanently installed lighting systems.
-
When equipment goes bad out in the field, it's often extremely helpful if the owner/end user can keep track of the circumstances of the failure. This is especially true when the problem is intermittent and might not occur when the technician is present. Service Technicians are exceptionally skillful...
Posted to
ETC Product Wiki
by
Kelsey Aleckson
on
08-24-2009
Filed under: AAS, Acclaim, arri, ASTS, AVAB, CEM, CEM+, Congo, CongoJr, cRRFU, DAS, Dimmer, Distribution, DMX, ECMUX, Element, ELTS, Emphasis, Eos, ETCLink, Ethernet, Express, Expression, GCE, Idea, Ion, Irideon, K96, KnowledgeBase, Legacy Unison, LMI, Lon, MDD, MDR, MicroII, MicroVision, MIDI, MPE, NCE, Net2, Net3, Obsession, ObsessionII, Pharos, RDM, Response, RFR, RFU, RRFU, RS-232, RVI, Sensor, Sensor+, SineWave, SmartBar, SmartFade, SmartFadeML, SmartModule, SMPTE, Source Four, Source4, Touchscreen, Unison, Vision, WRFU
-
If there is no backlight output, there are 2 options for the enduser to choose from: Check T1 for damage. If physically damaged or T1 is making a squealing sound, it needs to be replaced by a certified ETC technician. Check the RFU configuration to see if the backlight timer is on. The default setting...