-
This is a link to a PFD that lists the DMX control channels for and AR5, AR6, AR7 and AR500 and its versious modes for dmx interpreter ver 3.0. 3060.Irideon DMX chart.pdf
-
If for some reason an MCP misses a scheduled action due to power outage or other interruption, it will NOT play the last look or last scheduled action. Scheduled actions will not play until they reach the next time an action is scheduled. For example: We have a schedule set to have lights turn on at...
-
When using an Irideon DMX-I; DMX channel 512 is used as a global command for all fixtures. To activate a global command, set and hold the assigned level for 3 sec then restore the level to 00. Command Level Reset 33% Douse 66% Start 99%
-
Manuals Irideon AR50 Owner's Manual Irideon AR50 Installation Manual Irideon AR5 Owner's Manual Irideon AR5 Service Manual 8372.Irideon AR5 V.2 Owners Manual 1998.pdf 1680.Irideon AR5 V.2 Service Manual 1997.pdf 6886.Irideon AR5 Service Manual Vari-Lite.pdf 3755.Irideon AR50 User Manual RevA...
-
Question: How many fixtures and DMX channels can I connect to a MCP? Answer: There are two ports for Irideon fixture control data and a third port used for DMX output. This does mean that you can output data to 62 Irideon fixtures (31 on each data bus with 1000' Max data wire run) with DMX output...
-
Check the MotorsEach motor has two pairs of control wires. To make sure that the wiring is good and the motor is not shorted, meter between each pair of wires with the control card disconnected. The measurements must be made with the unit powered off. The pairs are listed below. You should read between...
-
Question: How Do Irideon Colors Compare to Common Gel Colors? Answer: SEE ATTACHMENT: 5758.Irideon_color_system.pdf
-
Question: What are the channel assignments for an Irideon AR6 fixture running on a DMXi interpreter? Answer: AR6 channel assignments for DMXi 16 Bit 13 Channel mode: Intensity Coarse Pan Fine Pan Coarse Tilt Fine Tilt Color Gobo Dummy Channel Dummy Channel Intensity Time Focus Time Color Time Beam Time...
-
Question: What is the maximum angle that a remote ballast AR500 head can turn, verticalyy and horizontally? Answer: If the Remote Head is pole-mounted, there is no restriction of the range of motion. If the unit is attached directly to a flat surface, such as a wall, the range of motion is reduced to...
-
There are two different types of receptacle stations a "Remote Programming Receptacle" and a "Luminaire Programming Receptacle" . Remote Programming Receptacle (MCP Remote Programming Receptacle) This has an RS232 interface that is designed to attach to the recall station data run...