-
*Menu structure is based on software v2.1.7 with a CEM+ that begins running in Full-Featured mode *If your rack does not have a configuration in it already, skip to step 6. Note: Basic/Portable mode is a simplified setup mode in CEM+ version 2.0 and above, intended for portable/touring racks. In basic...
-
Question: Seeing flickering in a rack. Could this be due to an airflow problem? Answer: Yes it can. The rack can get caught between system ok and airflow error. This can cause flicker. If all of the dimmers that are active in the rack always flicker out together, airflow could be a factor. If they change...
-
Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
Posted to
ETC Product Wiki
by
Tracy.Fitch
on
08-26-2011
Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU
-
Manuals Sensor+ CEM+ v3.1.0 User/Configuration Manual Sensor+ CEM+ v3.0.0 User/Configuration Manual Sensor+ CE Installation Manual Sensor CEM Configuration Manual v1.0.2 Sensor CEM Configuration Manual v1.2.0 Sensor CEM Configuration Manual v2.0.0 Sensor CEM Configuration Manual v2.2.0 Sensor CEM Configuration...
-
Verify that the Max Scale setting for each dimmer on the CEM+ is set to about 118. Verify that the Curve setting for each dimmer on the CEM+ is set to Mod Square. If this doesn’t work, try Sensor 2.0. Make sure to check the voltage readings with a True-RMS meter. NOTE: Any work (including metering...
-
The content of this article has been merged into another entry: How do I change the contrast on my CEM+
-
To change the contrast of the LCD display on a CEM+ with a blue main circuit board: --Press and hold the double back arrow (<<) and use the plus (+) and minus (-) keys to change values. Changing the contrast of the LCD display on a CEM+ with a green main circuit board requires adjustments on the...
-
Problem: Dimmer modules slide out about 1/2" during transport of the rack. Modules must be re-seated before each use. Solution: Install (2) 7053A3087 Module Retainers per door (i.e. 2 per SP24, 4 per SP48). This will help to hold the modules in place.
-
*Menu structure is based on software v2.1.7 *If your rack does not have a configuration in it already, skip to step 6. Scroll to [Login] Enter the password 3,3,3,3 (scroll up to 3 and hit checkmark, etc.) Scroll to [Rack] and hit the checkmark Scroll to [Delete All Racks] and hit the checkmark It will...
-
How much power does the CEM+ Use? 0.25A Peak 0.14A Normal/Idle