-
CEM+/CEM3 The ELV module circuit must be powered (with the breaker on) before getting a control signal in order for the module to output. Why? The processor in the ELV module needs to see a zero on the pwm line before it is ready to output. With CEM+/3, test mode supplies a constant +5V signal starting...
-
Users with Internet Explorer 9 and above will not be able to connect to CEM+ versions before 3.0. Solution The difficulty is a component of the javascript code only recognizes internet explorer with major versions 5, & 6 (7 is also supported in version 2.2). When IE9 identifies itself with that number...
-
Users with Internet Explorer 7 will not be able to connect to CEM+ (at least up through CEM+ version 2.1). Solution The difficulty is a component of the JavaScript code only recognizes internet explorer with major versions 5 and 6. When IE7 identifies itself with that number, the JavaScript code exits...
-
Users with Internet Explorer 8 and above will not be able to connect to CEM+ versions before 3.0. Solution The difficulty is a component of the javascript code only recognizes internet explorer with major versions 5, & 6 (7 is also supported in version 2.2). When IE8 identifies itself with that number...
-
Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
Posted to
ETC Product Wiki
by
Tracy.Fitch
on
02-29-2012
Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU
-
When installing SineWave dimmer modules in a Sensor+ rack, always insert modules starting at the bottom of the rack and work your way up. As you insert each module, make sure it is fully-seated in its slot and that the bus bars make proper contact with the module.
-
Manuals Sensor+ SineWave Rack Installation Manual Sensor+ SineWave Brochure Sensor+ SineWave Rack Knowledge Base: Help Your Technician Help you Viewpoint - Rise Time: Facts and Myths How much noise does a Sensor+ SineWave rack make? Proper Installation of Dimmer Modules in Sensor+ SineWave Racks
-
For instructions about how to use Sensor3 Power Control system specific to CEM3 operation, terms, and definitions, also see CEM3 Power Control page. Sensor3 is the foundation for a versatile power system that builds on our proven Sensor workhorse system with CEM3 control. Sensor3 is coming soon to installation...
-
*Menu structure is based on software v2.1.7 with a CEM+ that begins running in Full-Featured mode *If your rack does not have a configuration in it already, skip to step 6. Note: Basic/Portable mode is a simplified setup mode in CEM+ version 2.0 and above, intended for portable/touring racks. In basic...
-
Question: Seeing flickering in a rack. Could this be due to an airflow problem? Answer: Yes it can. The rack can get caught between system ok and airflow error. This can cause flicker. If all of the dimmers that are active in the rack always flicker out together, airflow could be a factor. If they change...