-
What are Unique Dimmer Numbers? Sensor Unique Dimmer Numbers (UD#'s) are a new addressing scheme introduced with Sensor version 3.0 software. Unique dimmer numbers allow multi-rack systems to reference discreet, absolute dimmers beyond 512. In 2.x versions of CEM code, you merely entered a Starting...
-
On the first (primary) PCB of a Sensor SBS station, the jumpers should be set to 1 and 5. On the second PCB of a Sensor SBS station, the jumpers should be set to 2 and 6.
-
If Sensor racks are not mounted on a wall, there are keyholes on the rear of the rack which need to be covered. If these holes are left exposed, one could reach in and contact the bus bars. There is a kit to cover these holes. The kit contains (3) plates and (6) screws. The P/N for the kit is 7051K1001...
-
The Pass-through Cam-Lok connectors on Sensor Touring racks are NOT UL or cUL rated.
-
Question: What are the Fuse Changes for a Delta CEM? Answer: CEMD (120V Delta CEM) F2 changes from 1/8 Amp to 1/2 Amp. HCEMD (240V Delta CEM) F2 changes from a 1/8A. to 1/2 A. F3 changes from a 2A. to a 1A.
-
Sensor/Sensor+ Delta Rack Knowledge Base: Sensor Delta Rack J1 Pinout What are the Fuse Changes for a Delta CEM?
-
Sensor Backup Station (SBS) Pinout Pin Signal 1 12Vdc 2 GND 3 ETCLink Data - 4 ETCLink Data + This same pinout is also used for DAS stations.
-
Question: How Do I Wire and Use CEM Panic? Answer: CEM Panic is a contact closure which is wired to the CEM backplane in a Sensor rack. When the contact is closed, all dimmers which have been recorded into the Panic look are brought to full. Note that in multi-rack systems, the Panic switch is wired...
-
There are three fuses labeled F3-5. F3 and F4 are 1/8 Amp, F5 is 1.5 Amp F3 is C phase detect F4 is B phase detect F5 is A phase detect and supplies power to the MPE and the fan.
-
Question: How Many Load Grounds Can Land in a Sensor SR48? Answer: The SR48 Ground Bus Assembly, part # 7051A2020 can accommodate up to 72 landed wires. However, if you need to land more than 72, you can Scotch-Lok into the existing landed ground wires, or install a utility box next to the rack. Within...