-
ETC uses the Neutrik zero-degree pin offset, 6-pin connector for all 6-pin XLR remote focus unit connections.
-
For version 5.2.0 and above: Load the show into the Obsession Offline Editor (OLE). This can be accomplished by either: Put the ETCSHOW.DAT and ETCSHOWS.DIR files onto a floppy diskette in drive A. Note: The filenames are hardcoded. If you have changed the names, rename them back to the original filenames...
-
OBSN 1 & 2: Show Saving and Loading Definitions Only one option for saving shows: [STORE SHOW] Saves show, patch and all system settings except the I/O Configuration. I/O configuration includes DMX port addresses, multi-user, MIDI, SMPTE and all other options in the Input/Output Configuration section...
-
Question: How Do I Adjust SMPTE Level on the Obsession II? The Obsession II PU I/O PCB does not include a SMPTE like the Obsession. Answer: The new SMPTE chip has an AGC (Automatic Gain Control) circuit built in that automatically adjusts the level of the incoming signal.
-
There were only a handful of hardware changes for the release of the Obsn II DRC. The Obsn II DRC is really a chopped up version of a Obsn II console. DRC has no submasters or faders DRC only supports UTP (twisted pair) network type. The BNC (thinnet) connector was removed from the back to allow space...
-
Question: What are the software changes for the release of the Obsession II Designer Remote Console (DRC)? Answer: Which versions of software support the Obsn II DRC? The Obsession II DRC was first supported in V4.2 and in all subsequent releases. Is their a new new device ID found in the diagnostic...
-
Question: Why Isn't the Obsession II Console Power Supply Enclosed? ETC had to enclose the power supply in Universal Expression 2 consoles. Answer: The reason that the Expression 2 has the power supply covered is for safety. You can open up the Expression 2 without a tool and get at the dangerous...
-
Question: Are the mounting holes on the front panel and rear 'mounting wings' a suitable size for M6 screws (as used in Europe)? Answer: Yes, the mounting holes will accept M6 style screws.
-
Question: Can you upgrade an existing Obsession II Single Processor System to a Dual Processing System by buying another processor? If so, are there any upgrades or changes that must be done to do this? Answer: Tracking systems require both processors to have identical channel counts, CPU speeds, HD...
-
SEE ATTACHMENT: 2273.Obsession_II_Software_Release_Notes.pdf