-
ETCNet2 Network Configuration Editor (NCE) does not ship installed on an Eos Family console, but can be installed at any time. NCE is a useful tool used to configure Net2 DMX nodes, Net2 Video nodes, Net3 Gateways running in Net2 mode, and Net3 1 port gateways. To install NCE on an Eos Family console...
-
NOTE: The following 1-port gateway issue was resolved in Eos Family software version 1.9.1 and higher. If you are experiencing this issue, please update to the latest version of software, if able, and check to see if the problem persists. 1-PORT GATEWAY ISSUE There have been reports of issues with 1...
-
Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
Posted to
ETC Product Wiki
by
Tracy.Fitch
on
08-26-2011
Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU
-
Two Port Wallmount Node Two Port Touring Node The ETCNet2 Two Port Node was available as either a wallmount (backbox mounting) version or as a touring version with either two male or two female 5 pin XLR connectors. Similarly to other Net2 products the connectors can be inputs or outputs irrespective...
-
The ETCNet2 DMX Node provides a way to either input or output DMX from a Net2 Network system. The node can also be used in a Net1 system similar to an RIU. There were several variants produced : Connectors could be either front or rear mounted DMX connectors were available as 4 male, 4 female or a mixture...
-
VersionDetect Not working with two ports. ETCNet2 Two Port DMX Nodes prior to v4.0.0 will not understand an Update command from VersionDetect as indicated by the icon. To update these nodes with the version of software the nodes are currently in. This is because two ports prior to version 4 need RCC...
-
Network Configuration Editor (NCE) ETC's Network Configuration Editor (NCE) is a spreadsheet-style software program designed to make configuring ETCNet2 TM DMX and Video nodes easy. With NCE, you can configure the paramaters of any port on any ETCNet2 node in a NET2 system. Through an Ethernet connection...
-
Problem: My RFU will not work with my Net2 Video Node. Answer: Make certain that you're video node is running 2.0 code.
-
Question: In which direction do you move the termination switch on the ETCLink/RFU PCB to terminate? Answer: Towards the J5 connector is terminated
-
Attached are the instructions for configuring an ETC supplied Dell Ethernet Switch for a typical ETCNet2 and Net3 installation. Note that switches generally ship configured from ETC, these instructions are for reference in case a switch needs to be reset. 3771.4000M2202_revA.pdf