-
Question How Do I Clear Overtemp and Airflow (and other) Errors On The Sensor CEM? Answer Several of the errors that are considered to be critical to the well-being of the Sensor rack continue to display after error status is no longer present. These are referred to informally as "sticky" errors...
-
Arch Failure indicates that the Architectural Portion of the Processor has failed. This can be the result of a few possible failures listed below. A hardware problem with the processor A problem or corruption in the configuration Anything that would cause Light Manager to generate a P80 Error will cause...
-
Product Line: Obsession family of consoles Description: System software version 3.1.2 Engineering Change Order (ECO): 3461 Effective Date: 3/18/98 Version 3.1.2 is a software upgrade for Obsession consoles that meet all the requirements specified below. Consoles that do not meet these requirements can...
-
To set up the Obsession 1 CMOS: You may need to re-setup the CMOS/BIOS of the console if it boots to a CMOS or hard drive error. The battery that maintains the memory for the CMOS may have discharged, causing the CMOS data in the console to be lost. Use the following steps to input that data. The battery...
-
Product Lines: Obsession II Lighting Control Systems (all models) Description: Version 4.4 software upgrade Purpose: This document explains how to install Version 4.4 system software in an Obsession ® II system and ensure the compatibility of software in all associated network devices. If you have...
-
There is a topology issue to consider with SmartLink interconnected S-ACPs that can result in erratic system response to SmartLink commands. The issue only affects systems with two or more S-ACPs on the SmartLink bus. A single S-ACP connected via SmartLink to SmartPack, SmartSwitch, or CEM+ with SmartLink...
-
Setting System ID System ID must be changed in 2 places, then the Emphasis Application, as a whole, needs to be shut down and rebooted. This can only be done from System Manager or ask ETC Tech Services . Login as System Manager Launch Emphasis Minimize Application Performed in Emphasis Console Application...
-
The pointing device needs to be a DOS compatible Mouse/Track ball that does not need to have any drivers loaded in order to work. Logitech Mouse/Trackballs usually work well. The console uses a DB-9 connector (as opposed to a DIN-style). Devices known to work: Logitech M/N T-CM14 Serial Marble Mouse...
-
SMPTE is not directly supported on the Express line of control consoles. However, the Express line does support ETC MIDI , MIDI Show Control (MSC) and MIDI Time Code so it's possible to use SMPTE with an Express console if you use a SMPTE to MIDI generator. Enable the type of MIDI you wish to use...
-
On older Source Four's the lamp may work its way out of the socket as the fixture heats up and then cools down. This can cause arcing and pitting of the sockets and the lamp pins, which will result in damage. To avoid this: Open up the endcap and verify the following. Make sure that the lamp retainer...