-
Users with Internet Explorer 7 will not be able to connect to CEM+ (at least up through CEM+ version 2.1). Solution The difficulty is a component of the JavaScript code only recognizes internet explorer with major versions 5 and 6. When IE7 identifies itself with that number, the JavaScript code exits...
-
Users with Internet Explorer 8 and above will not be able to connect to CEM+ versions before 3.0. Solution The difficulty is a component of the javascript code only recognizes internet explorer with major versions 5, & 6 (7 is also supported in version 2.2). When IE8 identifies itself with that number...
-
Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
Posted to
ETC Product Wiki
by
Tracy.Fitch
on
02-29-2012
Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU
-
*Menu structure is based on software v2.1.7 with a CEM+ that begins running in Full-Featured mode *If your rack does not have a configuration in it already, skip to step 6. Note: Basic/Portable mode is a simplified setup mode in CEM+ version 2.0 and above, intended for portable/touring racks. In basic...
-
In non-dimmed applications, branch circuits are often installed with three circuits sharing a common neutral conductor, where each of the three circuits is on a different phase. This is known as a “multiwire” branch circuit arrangement. It is used to save costs because only four total conductors...
-
Verify that the Max Scale setting for each dimmer on the CEM+ is set to about 118. Verify that the Curve setting for each dimmer on the CEM+ is set to Mod Square. If this doesn’t work, try Sensor 2.0. Make sure to check the voltage readings with a True-RMS meter. NOTE: Any work (including metering...
-
We often get asked about wire temperature ratings and how they relate to dimmer rack wiring and the allowable number of circuits in a conduit or wireway. While the ultimate authority on wire size, temperature ratings, and conduit fill is the project electrical engineer, and then the local inspector,...
-
*Menu structure is based on software v2.1.7 *If your rack does not have a configuration in it already, skip to step 6. Scroll to [Login] Enter the password 3,3,3,3 (scroll up to 3 and hit checkmark, etc.) Scroll to [Rack] and hit the checkmark Scroll to [Delete All Racks] and hit the checkmark It will...
-
Note: Basic/Portable mode is a simplified setup mode in CEM+ version 2.0 and above, intended for portable/touring racks. In basic/portable mode, the only active DMX is port A input. Once a unit is configured and running in basic/portable mode, anyone can press checkmark from the front panel to quickly...
-
CEM+ SMARTLINK POWER BOARD 2 7150B5620 LED Indicator Guide LED Color Component Location Purpose Default/Normal State Red CR1 Indicates a voltage imbalance on the LON network favoring NET B OFF (May glow slightly) Red CR2 Indicates a voltage imbalance on the LON network favoring NET A OFF (May glow slightly...