-
The Relfexion / Reflection console has two modes for DMX pass-through: buffered and byte for byte. (This is valid after software version 2.06). The latter mode sometimes fails on modern DMX consoles with the expanded speeds allowed by DMX512:1990. Early version Reflexions were set to Byte-for-Byte, which...
-
If the console loses memory after being turned off for a short amount of time (less than a month), please call ETC or your local ETC Service Center in order to get the console in for repair. It is most likely a problem with the SRAM memory on the desk.
-
Manuals Expression (1) User Manual Expression 3 User Manual Expression 2x User Manual Insight 2x User Manual Insight 3 User Manual Insight User Manual Insight 2 User Manual 6811.Expression ML Module User Manual v3.0.0 1998.pdf 6712.Expression ML User Manual v3.0.0 1998.pdf 8468.Expression User Manual...
-
Problem: Occasionally lights will randomly turn on after the console is turned off. Answer: When an Expression family console (Expression, Express, Insight) is turned off, there is some power still left in the power supply. This additional power can cause unstable or unexpected data signals to travel...
-
Expression Off-Line v3.1 gives you the option to merge showfiles. Normally when a show is read from disk into either Off-Line or the console, the current show in memory is erased. This prevents you from merging two shows together or reading portions of one show into another one. This barrier can be overcome...
-
The software version (main operating code) can be found by hitting the [Setup] key. The version number is located in the lower right hand corner of the monitor screen. Note: As the console boots up you will see the version of boot code that the console has. Do not confuse this with the main operating...
-
The software version (main operating code) can be found by hitting the [Setup] key. The version number is located in the lower right hand corner of the monitor screen. Note: As the console boots up you will see the version of boot code that the console has. Do not confuse this with the main operating...
-
ETC uses the Neutrik zero-degree pin offset, 6-pin connector for all 6-pin XLR remote focus unit connections.
-
Question: Where is the Trim Pot located on the PS107? Answer: Please see the attached image for location of this trim pot. SEE ATTACHMENT:
-
RFU's for Expression 2/3 (RFU2's) and Obsession RFU's runing on ETCNet2 DMX Nodes and ETCNet2 Video Nodes may blow capacitor C7 if the Node is on a supply greater than 16vdc. In other words, new nodes should get new RFUs or replaced caps in RFUs. Copied below is the ECO (5316) which changes...