-
Manuals Expression (1) User Manual Expression 3 User Manual Expression 2x User Manual Insight 2x User Manual Insight 3 User Manual Insight User Manual Insight 2 User Manual 6811.Expression ML Module User Manual v3.0.0 1998.pdf 6712.Expression ML User Manual v3.0.0 1998.pdf 8468.Expression User Manual...
-
Problem: Occasionally lights will randomly turn on after the console is turned off. Answer: When an Expression or Express line console is turned off there is some power still left in the power supply. This additional power can cause unstable or unexpected data to travel to the dimmer racks. Occasionly...
-
It's to do with the mode. Relexion has two modes; buffered and byte for byte. The latter mode sometimes fails on modern fast consoles. Early version Reflexions were set to BFB which I suspect is what they have. Buffered mode should completely solve this problem at the expense of a tiny extra delay...
-
Question: Where is the Trim Pot located on the PS107? Answer: Please see the attached image for location of this trim pot. SEE ATTACHMENT:
-
RFU's for Expression 2/3 (RFU2's) and Obsession RFU's runing on ETCNet2 DMX Nodes and ETCNet2 Video Nodes may blow capacitor C7 if the Node is on a supply greater than 16vdc. In other words, new nodes should get new RFUs or replaced caps in RFUs. Copied below is the ECO (5316) which changes...
-
Problem: ETCLink hardware Not Installed If ETCLink wiring and Sensor CEM's show that ETCLink is operating correctly, check the CPU on the Expression 2/3 console. In Europe , DIP switch 1 is DOWN (ON). In the US , DIP switch 1 should be UP (OFF). Workaround / Fix
-
The monitors are jumping between screens and taking random key hits. It looks like a nasty macro is running. This generally means that the ETCLink and RFU cables are plugged in reverse order. Both have female 6-Pin Female XLR connectors. On the Expression series the connectors are side by side, and on...
-
Here is the Expression/Express Programming cheat sheet: Patch dimmers to channelsIn Patch display: Enter dimmer number(s). Can use [And] and [Thru] commands Press Enter.Enter channel number.Press Enter.To unpatch dimmersIn Patch display:Enter dimmer number(s). Can use [And] and [Thru] commands Press...
-
The software version (main operating code) can be found by hitting the [setup] key. Software version is located in the lower right hand corner of the monitor screen. FYI, as the console boots up you will see the version of Boot code that the console has. Do not confuse this with the main operating code...
-
Printers tested and/or sold for Express and Expression consoles HP-812c InkJet printer HP-810 Inkjet Printer Brother HL-1240 HPdeskjet 500 Epson 5000 Panasonic KX-P11801 Cannon BJC 4000 Panasonic KX-P4410Digital, DEC Colorwriter 120ic Make sure you verifie pin out and dip switch settingsIf having trouble...