-
DMX has a number of timing variables. The information presented here will probably be useful for only a small proportion of users, but can assist in getting troublesome DMX equipment to work. If you need further information, the book " Recommended Practice for DMX512: A guide for users and installers...
-
Net3 One Port DMX Gateway Gateway Configuration Editor (GCE) ETCNet2 Network Configuration Editor (NCE) DMX Ethernet Knowledge Base: 1-Port Gateways Drop Out ETC Network IP Addresses One Port Gateways Cannot Communicate with NCE Updating 1-Port Gateways to work in GCE Problems with Strand SN110 node...
-
Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
Posted to
ETC Product Wiki
by
Tracy.Fitch
on
02-29-2012
Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU
-
.PDF Black Secrets of the Relay Cards Relay Controller Features Relay Rack Features These cards were offered for a time by ETC Ltd (UK). The attached Acrobat .pdf files contain some basic info on these cards. Note: There is no user manual available. Relay Driver Card Analog Output Card 6 Relay Add-On...
-
Two Port Wallmount Node Two Port Touring Node The ETCNet2 Two Port Node was available as either a wallmount (backbox mounting) version or as a touring version with either two male or two female 5 pin XLR connectors. Similarly to other Net2 products the connectors can be inputs or outputs irrespective...
-
The ETCNet2 DMX Node provides a way to either input or output DMX from a Net2 Network system. The node can also be used in a Net1 system similar to an RIU. There were several variants produced : Connectors could be either front or rear mounted DMX connectors were available as 4 male, 4 female or a mixture...
-
You cannot use a single ETCNet2 node as a DMX merger. HTP arbitration works via node address not by port address. Port addresses on a node are arbitrated like version 3 where the lower the port # the higher the priority. Imagine a scenario where you plug dmx jacks into ports 1 & 2 on a Net2 4 Port...
-
Question: How many fixtures and DMX channels can I connect to a MCP? Answer: There are two ports for Irideon fixture control data and a third port used for DMX output. This does mean that you can output data to 62 Irideon fixtures (31 on each data bus with 1000' Max data wire run) with DMX output...
-
VersionDetect Not working with two ports. ETCNet2 Two Port DMX Nodes prior to v4.0.0 will not understand an Update command from VersionDetect as indicated by the icon. To update these nodes with the version of software the nodes are currently in. This is because two ports prior to version 4 need RCC...
-
Problem: My RFU will not work with my Net2 Video Node. Answer: Make certain that you're video node is running 2.0 code.