-
-
Effect Playbacks behave just as Channels do; they are HTP 1 for intensity and LTP 2 for non-intensity attributes. They are much like Channels that have a device patched to them. From moment to moment, the highest intensity level an effect is being told to play at, it will play at. However, the attributes...
-
A Color palette is a specific reference point for the color parameters of a device. W hen presets are recorded with devices using Color palettes, they do not record the absolute Color parameters of the devices; they reference those parameters from the however they've been recorded into the palette...
-
A Focus palette is a reference to a specific area on stage. When presets are recorded with moving lights using Focus palettes, they do not record the absolute positions of the fixtures; they reference the Pan and Tilt parameters of a Focus palette. If that palette then is updated to reflect a different...
-
Masking a Palette is very handy when you want some of the parameters in the Palette type to be “transparent” – for example: if you store a beam palette and mask out Iris you can recall this palette without affecting the Iris parameter – even if it normally is part of a beam palette...
-
Upon recording a palette, a dialog box appears that has two settings: Palette Name and Record Attributes for: The Record Attributes for: setting decides the behavior of a palette using the following options: [Each Device] and [Each Device Type] . [Each Device] is used when each individual device requires...
-
ETC uses the Neutrik zero-degree pin offset, 6-pin connector for all 6-pin XLR remote focus unit connections.
-
Note about screenshots: Entire columns of data have intentionally been removed to reduce the width of the graphics. Anything cropped/removed from the screenshots was not essential to this Wiki entry. With 80 Masters, it can be valuable to "hide" Masters or automate Masters so that you don't...
-
It's not unusual when programming to have to switch between docks and tab arrangements on the fly. It can be painful getting tabs rearranged in a timely manner if more than a few are open which is why you can record a screen layout to a direct select and recall it quickly later. A given screen layout...
-
Note about screenshots: Entire columns of data have intentionally been removed to reduce the width of the graphics. Anything cropped/removed from the screenshots was not essential to this Wiki entry. Time Masters can be used to dynamically change the Rate of a Chase Sequence on-the-fly. When a Time Master...