Response Network Controller

The Response Network Controller (RNC) was a combined protocol converter, DMX patch unit and HTP merger. It featured two input and two output ports supporting DMX, D192, K96 or AMX192 data protocols.

1. To connect to your Response Network Controller and configure its settings, you will have to download the linked software and follow the install.
     http://www.wiseterm.co.uk/wisetns-3.2.9-installer.exe
2. When complete, you can connect your Network Controller to your COM1 Port. To do this you may need a 25 to 9 Pin Serial Adaptor.
3. Under File>Settings, you can edit the Properties. Here you will need to change your Connection to Serial COM Port.
4. Next click on the Modem Port flag. Here you will need to change:
   • Port to COM1
   • Baud Rate to 38400
   • Parity to Even
   • Check the "XON/XOFF" on both Tx enable and Rx flow.

5. Click ok and on the Response Network Controller, click the reset button. After you should see a screen like the window below.
   

Knowledge Base:

• Help Your Technician Help you