Both Portable and Wall Mount SmartPacks easily switch from single phase to three phase operation, or vice-versa, by moving the power feed wires from the L2 terminal in the pack to the L1 and L3 lugs on the power board. Each SmartPack ships with a document including illustrations for this purpose.
A quick summary of the wire placements for both modes:
| Power Feed |
Wires on Each Terminal
|
|
L1
|
L2
|
L3
|
| 3 Phase |
1A, 1B
|
2A, 2B
|
3A, 3B
|
| Single Phase |
1A, 1B, 2A
|
|
2B, 3A, 3B
|
If wired incorrectly, your SmartPack dimmers may not fade properly or may jump to full when set at a low level. No worries, this just means that you didn't properly configure your pack for single or 3 phase operation.
The SmartPack will operate within a voltage range of 85-140VAC, 47-63Hz. This will allow the SmartPack to be used in countries with a power cycle of 50Hz.
Single Phase Setup 3 Phase Setup
