Note: The following tests will not run on fixtures that have a Composer Lite sequence loaded. A PC connected running Composer Lite is required to re-enable self test on the fixture.Internal diagnostic self tests are provided with the luminaire to exercise color and movement mechanisms. Set fixture address to “00” to initiate self tests.In self test, the Most Significant Digit (MSD) of the fixture address rotary switches regulates the rate at which the mechanisms move. Use the table below to determine test rates.Note: For pan and tilt movements, speeds below five seconds are not achievable to test full movement extremes. Observable speed differences for pan and tilt testing should be limited to settings between 5 and 9.MSD
0 maximum speed setting Rate1 1 second 2 2 seconds 3 3 seconds 4 4 seconds 6 6 seconds7 7 seconds8 8 seconds9 9 seconds
**These times do not apply to pan and tilt movements. With these time settings luminaire will operate at max pan and tilt speed (approximately 5 second rate from one extreme to the other).In self test, the Least Significant Digit (LSD) of the fixture address rotary switches selects the mechanisms to be tested. Use the table below to determine selected mechanisms.LSD Settings and Description
0 Cycles each mechanism [blue, amber, magenta, dimmer (douser) or diffuser, pan, then tilt] back and forth one at a time then all mechanisms at once.1 Cycles blue filter mechanism open and closed2 Cycles amber filter mechanism open and closed3 Cycles magenta filter mechanism open and closed4 Cycles dimmer (douser) or diffuser, whichever is installed, if any open and closed5 Cycles pan to limit extremes6 Cycles tilt to limit extremes7 Cycles each filter (blue, amber, magenta, then dimmer) open and closed8 Cycles pan then tilt to limit extremes9 Cycles all mechanisms at onceTo perform self test:
Step 1.
Set both fixture address switches (MSD and LSD) to “0”. Within five seconds the Green LED will begin to blink at a rate of on for two seconds and off for two seconds.Step 2.
Wait for approximately ten seconds. Within ten seconds the Green LED will begin to flash at a rate of two flashes per second. At this point the luminaire will begin self test, as detailed in the above tables, for the MSD “0” and LSD “0” condition. Once self test has begun, the MSD and LSD switches may be moved to other positions to test for proper operation of desired mechanisms. When all desired tests have completed perform Step 3. Step 3.
Return switches to the “00” address. Wait for slow flash of Green LED to indicate luminaire has returned to normal operation. When LED begins to flash at the slower speed, return address switches to original fixture address within ten seconds. Failure to begin setting address switches within ten seconds will return luminaire to test mode.Note: To exit self test mode, address switches must be moved to some test position other than “00” and then returned to “00”. If test is performed only at “00” LED will not resume slow flash to allow exit from testing.