Showing related tags and posts across the entire site.
-
Sensor CEM version 2 code does not have an "always on" firing mode but we can set a dimmer that way. To set a dimmer to be always on: Press [Setup] Press [1] for Dimmer Type the dimmer number on the numeric keypad and press [Enter] Press [4] to select Switched firing mode and press [Enter]...
-
Manuals Sensor CEM v3.1 User Manual CEM Classic The CEM classic was the control module supplied with Sensor dimming racks until the release of CEM+ in 2004. There were several versions produced for different voltage ranges. It is important to check the model of your unit when ordering spares Model Voltage...
-
If your relays are chattering or not firing in your Sensor, Sensor+ or Unison rack there may be a problem with the neutral wire on your signal distro card. Make sure that the neutral wire is present and connected on both ends. This problem can also cause ELV10 modules to not work correctly in test mode...
-
Manuals Sensor 230V Dimmer Module Datasheet Sensor Dimmer Modules Knowledge Base: What is the Curve on a CE (European) Sensor Module Breaker? Sensor Dimmer Module BTU Dissipation Non-dim vs Switched mode/Regulated vs. Unregulated Module Information Summary ELV10 And Test Mode In Sensor+ Why Are My Relays...
-
I have a pair of 96 channel Sensor install racks circa 1999. Both CEM displays read CONFIG MISMATCH but the dimmers have been responding normally. Untill now. I have a random circuit that is unresponsive to DMX commands from the console. The circuit has a dimmer doubler with a pair of Source 4 pars....
-
"Does anyone have a cheat sheet for the cem standard module for set up and to Re-set" For Software Version 3.0 and Greater Use these instructions to modify the rack type and/or dimmer modules that are used in the rack. These instructions should only be used if all of the dimmers in the rack...
-
The Physical Plant Manager at our facility thinks that, during "dark" days, we should shut down our 7) 96 racks to save energy by throwing the two main breakers. I've already told him that the rack fans shut off automatically and the CEMs don't use any power when inactive. I am correct, yes?
-
A little more info might be necessary to try and help... Are these install or tour racks? Is the problem happening in both racks at the same time? Is the same power source fed into both racks? How is data fed into the racks? hard-line dmx, network, any daisy chain, or data iso splitters? Is this the...
-
Today I have guest post by Bryan Palmer- a project manager at ETC. He emailed me a great study of our dimming past and dimming future. See his bright idea here . David