Showing related tags and posts across the entire site.
-
Two Port Wallmount Node Two Port Touring Node The ETCNet2 Two Port Node was available as either a wallmount (backbox mounting) version or as a touring version with either two male or two female 5 pin XLR connectors. Similarly to other Net2 products the connectors can be inputs or outputs irrespective...
-
The ETCNet2 DMX Node provides a way to either input or output DMX from a Net2 Network system. The node can also be used in a Net1 system similar to an RIU. There were several variants produced : Connectors could be either front or rear mounted DMX connectors were available as 4 male, 4 female or a mixture...
-
You cannot use a single ETCNet2 node as a DMX merger. HTP arbitration works via node address not by port address. Port addresses on a node are arbitrated like version 3 where the lower the port # the higher the priority. Imagine a scenario where you plug dmx jacks into ports 1 & 2 on a Net2 4 Port...
-
Question: How many fixtures and DMX channels can I connect to a MCP? Answer: There are two ports for Irideon fixture control data and a third port used for DMX output. This does mean that you can output data to 62 Irideon fixtures (31 on each data bus with 1000' Max data wire run) with DMX output...
-
Is there a way to enter levels as DMX values rather than a percent on the Obsession II? On an unrelated question, is there a way to map values in between the 5% profile points when editing a profile? I would like to create a profile that outputs 97% from 0 to 10% and then outputs 50% at 11%, 49% at 12...
-
I'm currently working on a show outside of our theatre and I made the mistake of trusting other people to load the truck and they forgot the road case with our Ion in it. I have the Ion client dongle and an Enttec USB DMX converter. Is there a way for me to use the client and the USB/DMX converter...
-
That sounds good. I've downloaded the software and read the manual. There are two other nodes on this network that still have their previously assigned IP address. In order to assign the defaulted node an address should I ---- 1. Connect all nodes to the network. 2. Plug my computer into the network...
-
Through a mistake of curiousity I restored the defaults on a Net# ACN 2 port DMX RDM gateway. Now when I plug the ethernet cable into the gateway it responds but says it is "Waiting for IP address server" What do I do to get the gateway to take up an IP address? Any help would be much appreciated!!!