Electronic Theatre Controls
Welcome to ETC's Online Community
All Tags » dmx » Net2 (RSS)

Browse Site by Tags

Showing related tags and posts across the entire site.

  • KnowledgeBase: ETC Network IP Addresses

    Default IP Ranges For ETC Products Below are the ETC Network addressing standards. Bold numbers or modes are the default for devices that ship with a preconfigured IP. These standard ranges should be used unless a different range is required by the site. ETC Product IP Range Congo 10.101.80.101 to 10...
    Posted to ETC Product Wiki by Tracy.Fitch on 06-18-2013
    Filed under: CEM+, CEM3, Congo, Congo Kid, CongoJr, DMX, Element, Emphasis, Eos, Ethernet, Gateway Configuration Editor, GCE, Ion, iphone, ipod, iRFR, IRFU, KnowledgeBase, Legacy Unison, Light Server, Mosaic, NCE, Net2, Net3, Network, Obsession, ObsessionII, Paradigm, Pharos, Sensor+, Show Control, Unison, WRFU

  • ETCNet2 Two Port DMX Node

    Two Port Wallmount Node Two Port Touring Node The ETCNet2 Two Port Node was available as either a wallmount (backbox mounting) version or as a touring version with either two male or two female 5 pin XLR connectors. Similarly to other Net2 products the connectors can be inputs or outputs irrespective...
    Posted to ETC Product Wiki by Tracy.Fitch on 09-16-2010
    Filed under: DMX, Ethernet, NCE, Net2

  • ETCNet2 Four Port DMX Node

    The ETCNet2 DMX Node provides a way to either input or output DMX from a Net2 Network system. The node can also be used in a Net1 system similar to an RIU. There were several variants produced : Connectors could be either front or rear mounted DMX connectors were available as 4 male, 4 female or a mixture...
    Posted to ETC Product Wiki by Tracy.Fitch on 09-16-2010
    Filed under: DMX, Ethernet, NCE, Net1, Net2

  • VersionDetect Not working with two ports in V 4.0

    VersionDetect Not working with two ports. ETCNet2 Two Port DMX Nodes prior to v4.0.0 will not understand an Update command from VersionDetect as indicated by the icon. To update these nodes with the version of software the nodes are currently in. This is because two ports prior to version 4 need RCC...
    Posted to ETC Product Wiki by Kelsey Aleckson on 07-23-2010
    Filed under: DMX, Net2
Page 1 of 3 (60 items) 1 2 3 Next >
Powered by Community Server (Commercial Edition), by Telligent Systems