Showing related tags and posts across the entire site.
-
You are on the right track. You do want to change your computers settings to the 10.101.x.x range of addresses if the nodes are on that default setting. I've not seen too many ETC Network setups where field technicians change from the default ranges, so you probably can get away with that as your start...
-
That sounds good. I've downloaded the software and read the manual. There are two other nodes on this network that still have their previously assigned IP address. In order to assign the defaulted node an address should I ---- 1. Connect all nodes to the network. 2. Plug my computer into the network...
-
Through a mistake of curiousity I restored the defaults on a Net# ACN 2 port DMX RDM gateway. Now when I plug the ethernet cable into the gateway it responds but says it is "Waiting for IP address server" What do I do to get the gateway to take up an IP address? Any help would be much appreciated!!!