-
USB connected. I went through the exciting and complicated process of upgrading my GCE, then upgrading the RFR, then testing yesterday. I will see if it reboots anymore today with 2.0.2 installed. Both still had the 2.0.11 installed by service. On a side note, can the RFR update notifications go out...
-
Has anyone had this issue: The RFR is not wanting to work when it's not plugged into its charging cord. It was working fine until a couple of days ago. I checked to see if it was just that the batteries may be run down and charged it for 24 hours. No change. It boots up fine, finds the base station...
-
Internet access is different than having access to the router or switch via TCP/IP. Just because you have to use a browser to set settings on your router doesn't mean that it has to have internet access. You would set up a closed network for your space. It could only consist of the console and the...
-
I called ETC on Thursday to see the status of the one RFR in repair and they said it was in testing with a new version of the software. I really hope testing goes well as the one I'm using in tech right now has started rebooting randomly even while plugged into USB power. I really need a working...
-
Here are my exact words to repair: Immediately after the upgrade, I noticed that upon turning the RFR on, it would reach the "Live" screen and then immediately reboot. All through this reboot cycle, the battery indicator would be one or two pixels wide, even though the unit had been plugged...
-
If you have not upgraded your RFR to 2.0 yet, and can live without the networkable base station, I recommend waiting. Both of mine are now only functional while plugged into USB power. The tech support guys are stumped and say they're seeing it with other units besides mine. One of mine is in ETC...
-
Corey, Thank you for the clarification. I figured that was the case, but I could not find it stated in any of the documentation. The closest thing I found was on the spec document where it stated " 3. A signal LED shall illuminate when the receiver is receiving radio signal from the transmitter...
-
[quote user="bosox242"] I just updated to 1.4.4 without updating RFR firmware and my RFR seems to be functioning correctly. Is it fine to use the RFR as is for the near term until I can get a computer with the GCE software on it and update the RFR? [/quote] The V2.0.0 Firmware for RFR adds...
-
[quote user="Anne Valentino"] 1.4.4 requires new firmware to be installed on both the RFR base station and the handheld unit. There are three ways to install this firmware. (Please see the release note on the downloads page of the RFR.). To install the firmware directly from the Eos/Ion shell...
-
Yeah, I have a Mac, too. Steve from tech support gave me instructions on a full console re-image in order to get XPe updated (which I will eventually do, but it involves completely wiping all saved data and settings). I will investigate other methods to update the RFR for now. Does GCE work on the RVI...