-
Greetings All, I am not a lighting professional. I a computer programmer by trade, and a audio/video hobbits. I volunteer at my church to run our lighting system. By watching the tutorials and reading the books I’ve learned how to run the SmartFader ML for our purposes. We currently have 4 Intelligent...
-
Here is my story, I working in an old building where the Smart Fade and Smart Soft are downstairs and I am up the catwalk trying to aim lights. The when i want to aim a separate part of the stage I have to walk downstairs switch the faders and climb back up again. Is there anyway that i can either network...
-
I have managed to set up network setting on the Congo and Laptop using a fixed IP address. I still get no Client option on the startup on the laptop. Drivers are installed and show under sytem when I insert the dongle. Both are running the latest update - setting seem to be the same as far as I can tell...
-
You are on the right track. You do want to change your computers settings to the 10.101.x.x range of addresses if the nodes are on that default setting. I've not seen too many ETC Network setups where field technicians change from the default ranges, so you probably can get away with that as your start...
-
That sounds good. I've downloaded the software and read the manual. There are two other nodes on this network that still have their previously assigned IP address. In order to assign the defaulted node an address should I ---- 1. Connect all nodes to the network. 2. Plug my computer into the network...
-
Through a mistake of curiousity I restored the defaults on a Net# ACN 2 port DMX RDM gateway. Now when I plug the ethernet cable into the gateway it responds but says it is "Waiting for IP address server" What do I do to get the gateway to take up an IP address? Any help would be much appreciated!!!
-
sclausen: I believe if you install NCE or GCE on your console, you will get buttons in the Settings (the system settings available from the startup screen) to launch those programs. Also, Net3 Services may be installed on consoles running v5.0.x software to provide DHCP and time server functions from...
-
My two cents: If you don't want to worry about IPs in the future and this is an isolated network, I would consider enabling the DHCP (Address Service) located in the Network tab. As long as the adapter on the laptop and the future backup console is set up to use DHCP everything will happen automatically...
-
Hello, For Congos and CongoJr the recomended IP ranges are 10.101.80.101 to 10.101.80.253 and 10.101.81.101 to 10.101.81.253. So you could make your Congo be 10.101.80.101 and the Jr 10.101.80.102. The NCE and GCE buttons in Congo Settings in v 5.0.1 are for access to NCE (Network Configuration Editor...
-
I'm trying to set up a network with our Congo Jnr and Congo Client. On the console, in system settings under the network tab there is no entry under ip, or subnet mask. Use DHCP is not checked. If I enter an IP and subnet, it's only stays until I exit the system settings. No combination of restarting...