-
Hi All, I apologize if this has been covered before, I searched the topics first and didnt find anything... I have a fresh out of the box Net3 2 port node to go along with our new Ion console. I've gone into the Network Settings on the Ion Shell to configure the node, but I'm not having any luck...
-
Hi, I've got a small setup that is working great consisting of: ION console v1.9.1.9.0.30 Linksys SD208 10/100 switch Netgear Netgear WPN802 v2 WAP RFR connected via Net3 USB iRFR on iPod Touch v 1.1.42 (through WAP) This setup works great. All are connected via a Linksys SD208 10/100 switch. Both...
Posted to
Networking Discussions
(Forum)
by
Jaylaca
on
03-16-2011
Filed under: sACN Networking, USB, Net 3, Wireless, Network, iRFR, ion, CEM+, Sensor+, configuration, 10/100, rfr
-
In trying to set up my Ion again after receiving it from the shop, I'm unable to get it to fully communicate with my 2-port Net3 Gateway. As far as I can tell, I have all IP addresses assigned correctly: GCE recognizes the node, and I can even remotely flash the LCD screen as well as ping the node's...
-
Hey there, With the new Eos/ Ion SW 2 I like to test the RDM functionality. As I read I will need at least SW 5.1 for the net3 Gateway. But the newest SW I found on the Site is 5.0, which seems to be to old (RDM with Eos/ Ion doesn't work) Where can I get the right one? Thanks. Methi