-
Hello everyone, As I am putting together a small network of 6 four ports gateways I had strange result witch AIP and sACNwiew reading. First my gateways version is v3.1.0, my GCE is v2.0.1 and I got v1.2.0 of sACNview. When using an AIP, unused channels on a sacn universe show flickers on sACNview. For...
-
Hi All, I apologize if this has been covered before, I searched the topics first and didnt find anything... I have a fresh out of the box Net3 2 port node to go along with our new Ion console. I've gone into the Network Settings on the Ion Shell to configure the node, but I'm not having any luck...
-
Hi, I've got a small setup that is working great consisting of: ION console v1.9.1.9.0.30 Linksys SD208 10/100 switch Netgear Netgear WPN802 v2 WAP RFR connected via Net3 USB iRFR on iPod Touch v 1.1.42 (through WAP) This setup works great. All are connected via a Linksys SD208 10/100 switch. Both...
Posted to
Networking Discussions
(Forum)
by
Jaylaca
on
03-16-2011
Filed under: sACN Networking, USB, Net 3, Wireless, Network, iRFR, ion, CEM+, Sensor+, configuration, 10/100, rfr
-
In trying to set up my Ion again after receiving it from the shop, I'm unable to get it to fully communicate with my 2-port Net3 Gateway. As far as I can tell, I have all IP addresses assigned correctly: GCE recognizes the node, and I can even remotely flash the LCD screen as well as ping the node's...
-
Every piece of Theatre equipment has either a safety cable attached or a good spot to attach one. I've got 3 Gateways on various battons none of them have safety cables, nor can I find a decent place to clip or bolt one on. I don't trust the XLR outputs to hold the gateway it in the air, and...
-
Hi, Is there any anticipated coordination in the networking standards of ACN and AVB or are they destined to be entirely separate? If separate, can they co-exist with ACN devices being non-participatory? Would ETC and/or ESTA consider joining the AVB standard? http://www.avnu.org/ Eugene Palmer Theater...
-
Hi, We are running an Ion main, Gio backup, outputting to our dimmers through first universe of a four port gateway. When we power down the desks at the end of the night, we have an issue when the UPS powering desks and gateway is switched off - Random dimmers in the rig switch on. This doesn't happen...
-
Hey there, With the new Eos/ Ion SW 2 I like to test the RDM functionality. As I read I will need at least SW 5.1 for the net3 Gateway. But the newest SW I found on the Site is 5.0, which seems to be to old (RDM with Eos/ Ion doesn't work) Where can I get the right one? Thanks. Methi
-
Does anyone know if it is possible and what equipment is needed to achive a wireless link between the EOS console and a Net 3 Remote Video Interface? I'm looking to dave running out ethernet cables across auditoriums.