Hey! My school is doing a show where we have two lamps plugged into an edison to stage-pin connector and into a circuit. I scoured the manual to find how to make a circuit non-dim and couldn't figure it out. Please help!!!
You can do this by going into Patch and setting the curve on that channel/address to 905 which is "full at 1%"
The curve box will be in the lower right.
[Channel #] {Curve}[9][0][5][Enter] should do the trick.
Seth A. Starr - Service Technician - Barbizon Charlotte
Also, you can change the type of the fixture to Non-Dim. This will then cause the channel to show up with an ND on the channel tile:
To do this:
Hans Hinrichsen
ETC Technical Support Specialist
As a side note, why is there not a Full at 1% Non-Dim profile?!?!
If you need this then Dimmer Curve 905 is Full At 1% as mentioned above.
It's also really easy to edit dimmer curves if you need anything else - like Full at 2%.
Keep on trying till you run out of cake.
ETC Field Service, London
It's not that. I know about the curves. I just don't understand why there isn't a profile for it. I want the tile to have the ND in the channel display is all.
I never used such a profile, I consider it too easy to accidentally bump a fader above 1, and if I'm setting a level I'll use 100 for clarity. However, it is very easy to make a variation of an existing profile.
I tried to be very detailed, having just verified this on the offline. My apologies if its less that perfect.
If you create this profile in a file that you use to start all future shows then you'll never have to do it again. Otherwise you can merge just the fixtures from a previous file.
I hope that helps.
Rick Reid, LC
Silhouette LIghts and Staging