Hi All
I have a problem of Master Fader now.
If a memory is recorded in Master Fader 10 & 30 and Master Fader of 9 or 29 is raised, 10 or 30 will be execute suddenly for a moment even when nothing is being done on the board.
A reproduction method
1. It is not device or parameter specific.
2. Record preset of a position 1 and a color 1 to Fader 9 or 29.
3. Record preset of a position 2 and a color 2 to Fader 10 or 30.
4. Raise Fader 9 or 29.
WAITS for about 10 minutes. (Do not touch the borad)
Since the attribute of a moving device is LTP, a position, a color, etc. will change.
Would like a user that has a moving light connected to console check this to see if it is produced anywhere other then my consoles.
The problem does not always happen.
When it does it usually happen with in 5 min.
Have tried it with every version of software and in all types of fader setting.
This only happens on a Congo. Does not happen on a Jr.
Please let me know.
Best regerds,
Kani
Hi there -
When this happens, do you see the bold outline on master 10/30 indicating the master is "active"?
Does the entire contents of the preset on 10/30 get played back or only part?
Thanks -
Sarah
Sarah Clausen
Controls Product Manager
ETC, Inc.
Hi
The outline of Master fader is not displayed. For a moment, it is in the state which carried out the flash. This flash is too early and is not known. The contents of preset are reproduced.
However, all the positions and colors will be stopped on the way. Example :
Between Position 1 & positions 2
To the appearance between color 1 of Color wheel, and color 2
If fader is raised by Feder of 9 for standby, Intensity will carry out a flash for a moment. In this case, Preset having contained intensity of preset of 9 is assigned to fader of 10.
At Live attribute editer, where data is changed, it is displayed.
Best regards,
Your faders are almost certainly 'nudging' slightly above 0%.
This fault must lie with your particular setup - I've never heard of this happening to any other console at all.
Just to be certain, I spent the whole of today with a Congo console primed to show large changes if any Master moved and they didn't.- For this test, I assigned the R, G, B attributes onto Masters 9, 10, and 11, pre-set the attribute to 50% and left it with the relevant channel selected. In this situation, any movement of the Master would take control of the attribute.
So, a few things to check:
Finally, have you contacted your local ETC office yet? If not, give them a call and they can help you determine the cause and solve the problem.
Keep on trying till you run out of cake.