Electronic Theatre Controls
Welcome to ETC's Online Community

Repost [Group]

rated by 0 users
This post has 1 Reply | 2 Followers

Top 500 Contributor
Posts 32
JWilsonLX Posted: 07-03-2012 4:41 PM

Maybe I'm being lazy, but...

I'm working with a designer who frequently calls out multiple groups to be put at a single level i.e. "group 321 and group 301 and group 331 and group 311 at full," and pressing [Group] four time per command gets tedious. Is there a faster way to post the last target again?I was hoping something like [+][+] might work(so, [Group][1][+][+][6] would post Group 1 + Group 6 to the command line), but as of 1.9.11 it does not. So far this has only been a problem for me with group as other targets, like subs, seem to assume I'm talking about the same target until I terminate the command.

Does anyone know of a way to do this, or should I get used to just pressing [Group] a lot?

Top 75 Contributor
Posts 170

When selecting multiple groups, you don't need the plus. So, [Group] 1 + [Group] 6 is the same as [Group] 1 [Group] 6. 

-Josh

Page 1 of 1 (2 items) | RSS
Powered by Community Server (Commercial Edition), by Telligent Systems