Congo is not like whole hog for exemple, Invert PAN or invert tilt is only for invert control pan/tilt Wheel, if you want pan= tilt and tilt= pan use swap.
So in whole hog if you invert parameter ML, it position move to the opposite position but not with congo, it is like this.
I prefer that ML change it position when I invert parameter but invert choice is made when you start your show so it is not a big problem you make your cues after this.
It's a problem when you open an old show and ML are not install like when you make the show, invert pan or tilt can't help you to update your positions, you must do them again.
I have got the same problem last summer with my congo junior and VL2500.
It would be very nice if in the next release, invert pan an tilt invert control wheel AND position like Hog it is better for touring shows.
Printing play and patch for all ASC Show
When you change invert on Pan or Tilt or Both you must hit HOME on that device after you have changed it for this to take affect. This is good to have it in the device setting because if your like us you rig changes loads and movers are in diffrent postions, if you delete and add a device you have to check that all you FCB groups pallets are still correct and no changes have been made, so you change Pan and Tilt in device setting to suit where your device is without changing anything eles in your settings.
Hope this helps if not sorry :)
Crewe Lyceum Theatre http://www.lyceumtheatre.net/